Intulon
1 7/8 Vacuum Hose Coupler Accessory - OD 2.2 in ID 2.0 in - Counterclockwise Thread
1 7/8 Vacuum Hose Coupler Accessory - OD 2.2 in ID 2.0 in - Counterclockwise Thread
SKU:2CCWCPL-WH
Couldn't load pickup availability
- Vacuum hose coupler with outer diameter of 2.2 inches and inner diameter of 1.95 in
- Coupler only. Tube not included.
- For RIDGID 1-7/8 inch 10 foot dual layer hose (24608)
- 3D printed. Made in USA.
Share
Good for Ridgid hoses or 1 7/8 hoses that have a second protective wrapping on top. However, for a 1 7/8 hose with out the protective wrap it does not sit very snug, and in some cases moves around a little bit. I had to put some duct tape around to bulk up the hose to prevent too much air loss. I think ill have to put some silicone around it to get it air tight. I have other 1 7/8 hoses without the protective wrap and it seems to do fine so i guess it depends.
Aside from that I have not seen any or very many other things like this so great job on the 3D printing!
- 5 stars: 1 (100%)
- 4 stars: 0 (0%)
- 3 stars: 0 (0%)
- 2 stars: 0 (0%)
- 1 star: 0 (0%)
Good for Ridgid hoses or 1 7/8 hoses that have a second protective wrapping on top. However, for a 1 7/8 hose with out the protective wrap it does not sit very snug, and in some cases moves around a little bit. I had to put some duct tape around to bulk up the hose to prevent too much air loss. I think ill have to put some silicone around it to get it air tight. I have other 1 7/8 hoses without the protective wrap and it seems to do fine so i guess it depends.
Aside from that I have not seen any or very many other things like this so great job on the 3D printing!