Intulon
1 7/8 진공 호스 커플러 액세서리 - 외경 OD 2.2 in 내경 ID 2.0 in - 반시계 방향 나사산
1 7/8 진공 호스 커플러 액세서리 - 외경 OD 2.2 in 내경 ID 2.0 in - 반시계 방향 나사산
SKU(재고 관리 코드):2CCWCPL-WH
픽업 사용 가능 여부를 로드할 수 없습니다.
- 외부 직경 2.2 inches, 내부 직경 1.95 in의 진공 호스 커플러
- 커플러만 포함. 튜브는 포함되지 않음.
- RIDGID 1-7/8 inch 10 foot 이중층 호스(24608)용
- 3D 프린팅. Made in USA.
공유
Good for Ridgid hoses or 1 7/8 hoses that have a second protective wrapping on top. However, for a 1 7/8 hose with out the protective wrap it does not sit very snug, and in some cases moves around a little bit. I had to put some duct tape around to bulk up the hose to prevent too much air loss. I think ill have to put some silicone around it to get it air tight. I have other 1 7/8 hoses without the protective wrap and it seems to do fine so i guess it depends.
Aside from that I have not seen any or very many other things like this so great job on the 3D printing!
- 5 stars: 1 (100%)
- 4 stars: 0 (0%)
- 3 stars: 0 (0%)
- 2 stars: 0 (0%)
- 1 star: 0 (0%)
Good for Ridgid hoses or 1 7/8 hoses that have a second protective wrapping on top. However, for a 1 7/8 hose with out the protective wrap it does not sit very snug, and in some cases moves around a little bit. I had to put some duct tape around to bulk up the hose to prevent too much air loss. I think ill have to put some silicone around it to get it air tight. I have other 1 7/8 hoses without the protective wrap and it seems to do fine so i guess it depends.
Aside from that I have not seen any or very many other things like this so great job on the 3D printing!